FARGO electronics DTC510 User Manual page 69

RESTRICTED USE ONLY
Troubleshooting the LCD Messages (continued)
Message
Mag Encode
Failed
Multiple Cards
Fed
No ENC
Response
No MAG Encoder
No Ribbon
Installed
No Smart
Encoder
Pause...
Please Clean
Printer
Please Remove
Card
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Cause
Indicates that the card's
Magnetic Stripe was not
encoded properly.
Indicates that two or more
cards were fed from the
Card Hopper.
Indicates that there is no
response from the Encoder
control module.
Indicates that the Printer has
received encoding data, but
the Printer is not configured
with this Encoder type.
Indicates that the Printer is
trying to print with no print
Ribbon installed.
Indicates that the Printer has
received encoding data, but
the Printer is not configured
with this Encoder type.
Indicates the Printer is
paused.
This message appears every
3,000 prints to remind you to
perform the recommended
Printer maintenance.
Indicates that the card is
jammed in the Print Station
or card flipping area of the
Printer.
Fargo Electronics, Inc.
Solution
See Resolving the Failed Magnetic
Encode Error Message in Section 2,
page 95.
See Resolving the Card Feeding
Errors in Section 2, page 86.
See Resolving the No ENC Response
Error Message in Section 2, page 93.
See Resolving the No Magnetic
Encoder Error Message in Section 2,
page 93.
Install the proper print Ribbon and
press RESUME to continue or
CANCEL to reset the Printer.
See Resolving the No Smart Encoder
Error Message in Section 2, page 95.
Press the Printer's RESUME button to
continue or CANCEL to clear all
pending print jobs and reset the
Printer.
See the Cleaning the Printer
procedure in Section 4, page 228.
See Card Feeding Errors in Section 2,
page 86.
Continued on the next page
69