FARGO electronics DTC510 User Manual page 67

RESTRICTED USE ONLY
Troubleshooting the LCD Messages (continued)
Message
EE Checksum
Error
EE Memory Error
Ejecting Used
Card
Failed To
Initialize
Flipper Alignment
FPGA
FPGA Load Fail
FPGA Timeout
Head Lift
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Cause
Indicates that the permanent
circuit board memory is bad.
Indicates that the permanent
circuit board memory is bad.
Indicates that the system
Firmware has detected a
card already in the Printer.
Indicates that an unexpected
hardware error has occurred.
Indicates that the Printer is
unable to align the Flipper
table.
Indicates that an unexpected
hardware error has occurred.
Indicates that an unexpected
hardware error has occurred.
Indicates that an unexpected
hardware error has occurred.
Indicates that the Printer was
unable to raise or lower the
Printhead.
Fargo Electronics, Inc.
Solution
See Resolving the EE Checksum
Error in Section 7, page 246.
See Resolving the EE Memory Error
in Section 7, page 246.
This card has been ejected; however,
it may contain encoded data and
should be disposed of in a proper
manner.
See Board Errors in Section 7, page
246.
See Resolving the Flipper Alignment
Error Message in Section 2, page
108.
See Resolving the FPGA Error in
Section 7, page 247.
See Resolving the FPGA Error in
Section 7, page 247.
See Resolving the FPGA Error in
Section 7, page 247.
See Resolving the Headlift Error
Message in Section 2, page 105.
Continued on the next page
67