FARGO electronics DTC510 User Manual page 68

RESTRICTED USE ONLY
Troubleshooting the LCD Messages (continued)
Message
Head Resistance
Error
Head Voltage
Error
Hopper 1 Empty
Hopper 2 Empty
Invalid Flip
Command
Invalid Print
Ribbon
DTC500 Series Card Printer/Encoders User Guide (Rev. 5.0)
Cause
The LCD requires that a
value be input for the Print
Head Resistance.
A hardware fault has
prevented a correct setting
of the Printhead voltage.
Card Hopper 1 has run out
of cards. (Note: The Printer
will continue printing from
Hopper 2 if First Available is
set as the Card Hopper
Selection in the Driver.)
Card Hopper 2 has run out
of cards. (Note: The Printer
will continue printing from
Hopper 1 if First Available is
set as the Card Hopper
Selection in the Driver.)
Indicates that the Printer
received a command to print
both sides of the card, but
this model does not support
dual-sided printing.
Indicates an unauthorized
Ribbon.
Fargo Electronics, Inc.
Solution
Enter a value for head resistance in
the LCD's Printer Setup menu.
See Setting the Printhead Resistance
in Section 8, page 262.
A default value will be used.
See the Resolving the Card Hopper
Empty Error Message procedure in
Section 2, page 92.
See the Resolving the Card Hopper
Empty Error Message procedure in
Section 2, page 92.
Press CANCEL to reset the Printer or
RESUME to print onto two separate
cards.
Install a valid, Fargo-authorized
Ribbon and press RESUME to
continue.
See Resolving the Unknown Ribbon
Type Error Message in Section 2,
page 104.
Continued on the next page
68