Installation Method; Method Of Use - Omron NT31 Operation Manuals

Using a Memory Unit (NT31/NT31C without V1)
3-6-1

Installation Method

3-6-2

Method of Use

Note
DIP Switch Functions
58
Install the memory unit (NT-MF261) at the expansion interface connector at the
rear of the NT31/NT31C as shown in the figure below. (The expansion interface
connector is located underneath the "note" label.)
As shown in the figure below, a memory unit has two sets of four DIP switches, and
the operation is determined by the DIP switches that are set at startup.
1 2 3 4
OFF
SW1
Always confirm that the power to the NT31/NT31C is off before setting the DIP
switches.
- Do not touch the PCB (printed circuit board) directly with bare hands.
The functions of the DIP switches on the memory unit are indicated in the table
below.
S SW1
Switch
Automatic transmission (writing from the memory Automatic transmission (writing from the memory
SW1-1
unit to the PT)
Automatic transmission (writing from the PT to the Automatic transmission (writing from the PT to the
SW1-2
memory unit)
Manual transmission (Direction of transmission and Manual transmission (Direction of transmission and
SW1-3
bank used selected at the PT touch panel)
SW1-4 Reserved for system use (must be set to "OFF")
1 2 3 4
Factory setting is turned all to off.
OFF
SW2
Function
Section 3-6
Mounting screws
OFF: Not executed
ON : Executed
OFF: Not executed
ON : Executed
OFF: Not executed
ON : Executed