Setting The Time-Out Interval - Omron NT31 Operation Manuals

Various System Settings
6-9-12

Setting the Time-out Interval

Reference: Whether or not an error screen is displayed when a time-out error occurs is deter-
206
To set other memory switches, select the relevant screen using the [ ] (next
screen) or [ ] (previous screen) touch switch, then make the setting.
S To confirm the settings and quit the memory switch setting screen, press the
"Quit" touch switch. The settings made last will be set and the NT31/NT31C will
return to the "MAINTENANCE MODE MENU" screen.
S To quit the memory switch setting screen without confirming the settings, press
the "Abort" touch switch. The NT31/NT31C will return to the "MAINTENANCE
MODE MENU" screen with the previous settings still in effect.
The NT31/NT31C goes into the time-out error status if no response is received
from the host within a fixed time. The "Time-out Interval" setting specifies the time
lapse at which time-out is judged to have occurred.
The setting range is 0 to 10 seconds. The default (factory) setting is 1 second.
mined by the setting for the "Comm. Auto-return" memory switch.
Set the time-out interval by following the menu operation from the System Menu
shown below.
Select "Maintenance Mode".
Select "Memory Switch".
Press [ ] (next screen) or [ ] (previous
screen) to display the third memory switch
setting screen.
Section 6-9