Omron NT31 Operation Manuals page 592

Commands/Responses
9-3-9 Character string memory table write command
(Sent from host to PT)
Command
[Format]
Reference: The maximum number which can be specified for character string memory table
Response
[Format]
[Function]
[ESC] W S
1B 57 53
* *
d11 d12
* * * *
m : Check sum present/absent (1 BCD digit)
0 : Absent
1 :Present
t to t : Character string memory number written to (4 BCD digits)
1 4
0000 to 0499
d1 , d1 , ..., dn , dn :
1 2 1 2
Contents of the written character string memory tables
(1 to 40 characters)
00 to FF
In the case of character string memory tables allocated to the
host, specify the registered number of words multiplied by 2, and
in the case of character string memory tables not allocated to the
host, specify the data for 40 characters.
s , s : Check sum (2 hexadecimal digits)
1 2
When m is 0, omit this setting.
depends on the setting for numbers of character string table entries
(256/1000/2000) made at the Support Tool. However, it is not possible to write to
character string memory table of numbers higher than No.500 since they are used
only as a reading area.
Only if "Yes" is set for the "Response" memory switch, the response indicated be-
low is returned on normal completion.
[ESC] W S
1B 57 53
s , s : Check sum (2 hexadecimal digits)
1 2
This is always added (fixed as "25H").
S Writes specified data to the specified character string memory tables.
m t1 t2 t3
* * * * * *
(s1)
dn1 dn2
* * * * * *
H
0 0 s1 s2
30 30 32 35
Section 9-3
t4
* *
(s2) [CR]
0D
* *
[CR]
0D
581