Omron NT31 Operation Manuals page 395

Graphs
[Display Functions]
[Input Functions]
[Output Functions]
384
S Scale Distance and Scale Length
Specify the scale position and scale length in % format regarding the radius as
100%.
Scale distance (0
Specify the distance from the center of an analogue meter in % format regard-
ing the radius as 100%.
0% None (Scale appears from center point of an analogue meter)
50% Scale appears inside the analogue meter.
100% Scale appears on circumference of an analogue meter.
110% Scale appears 10% outside the circumference of an analogue
meter.
Scale length (10 10%) :
Specify the length from the scale position in % format regarding the radius as
100%.
No. of Division : Specify the number of the division which the scale should be
divided for the range from 0 to 100%.
Since it specifies the number of division which the scale should be divided,
"No. of Division" +1 scale lines are drawn.
Also, when "Display Sign" is ON, the same number of scale lines are drawn
both for -100
ignated No. of division
Example) No. of Division =
"Display Sign" is OFF
Center
Radius
Width rate
Scale distance
Analogue meters indicate numeric values in accordance with the "General" set-
tings. For details on the method of display depending on the "General" settings,
refer to "Common Attributes" (page 386).
Analogue meters have no input functions.
Analogue meters have no output functions.
"Display Sign" is ON
Scale length
Width rate
Section 7-10
Center
Scale length
Radius
Scale distance
des-