Pm-E 24-48 Vdc Power Module (6Es7138-4Ca50-0Aa0) - Siemens Simantic ET 200S Manual

Power modules

2.4 PM-E 24-48 VDC power module (6ES7138-4CA50-0AA0)

2.4 PM-E 24-48 VDC power module (6ES7138-4CA50-0AA0)
2.4
Properties
• The PM-E 24 VDC to 48 VDC power module monitors the supply voltage for all the
• You can use all the electronic modules except the 2DI 120 VAC Standard,
• Control interface (PIQ) and feedback interface (PII) in the process image for option
• The current status of the power module is stored in the status byte in the process input
• The PM-E 24 VDC to 48 VDC power module is suitable for fail-safe modules.
General terminal assignment
Note
Terminals A4 and A8 are only available at specified terminal modules.
Terminal assignment for PM-E 24 VDC to 48 VDC (6ES7138-4CA50-0AA0)
Terminal Assignment Terminal
2 L+
3 M
A4 AUX1
2-6
electronic modules in the voltage group. The supply voltage is fed in by means of the TM-
P terminal module.
2DI 230 VAC Standard, and 2DO 24 VAC to 230 VAC/1 A in the voltage group of the PM-
E 24 VDC to 48 VDC power module.
handling.
image (PII). This is updated irrespective of whether the "No Load Voltage" diagnosis has
been enabled.
Caution
Only connect the specified rated load voltage of 24 VDC to 48 VDC to the TM-P terminal
module of the power module.
The connected rated load voltage must correspond to the supply voltage of the electronic
modules in the voltage group.
Assignment
6 L+
7 M
A8 AUX1
L+ Rated load voltage 24 VDC to 48 VDC
•
M: Ground
•
AUX1: Protective-conductor terminal or potential bus (freely usable
•
up to 230 VAC)
Notes
Manual, Edition 10/2005, A5E00514527-01
ET 200S