Device Set Up - Zimmer CITrac Instructions For Use Manual

Device Set Up

Installing the traction After the transport and before switching on the device, make sure that the device is
properly fixed to the traction table. Always follow the installation instructions from the
device
traction table mounting bracket. If not present, follow the instructions below:
Function of holes on device baseplate:
Only a traction bank provided or recommended by Zimmer MedizinSysteme GmbH
must be used.
Install device on Hole A of the device fix on pin A of the installing plate (only on specific traction tables
therapy table / available)
mounting bracket Turn the device to setting position as intended (there are 3 positions for setting)
Fix the clTrac to the traction table plate by 4 M8 hand-screws.
A. Alignment hole with ø9.6mm
B. Alignment set pin holes with ø6.5mm
C. M8 Screw-holes for couch mount
D. M8 Screw holes for stand mount or mounting bracket
6
Page 7