7.3.
Recalibrating / adjusting sensors
See Sensor settings, page 39.
Pos: 81 /TD/Produkt instand halten/testo 330/testo 330 Instandhaltung_Zusatzfilter wechseln @ 6\mod_1279261725966_79.doc @ 66743 @
7.4.
Replacing additional filter
The additional filter provides added protection should problems
occur with the particle filter in the flue gas probe. The additional
filter is very rarely contaminated if the measuring instrument is used
normally.
> Check the additional filter (visually) periodically for
contamination and replace it if necessary.
1. Place the measuring instrument on its front.
2. Remove the service cover: Take hold of it at the markings
(arrows) using the index finger and thumb, press slightly, fold up
and remove.
3. Loosen the additional filter from the hose connection.
4 Plug the new filter (0133 0010) into the hose connection.
5. Attach the service cover and engage it in place.
Pos: 82 /TD/Produkt instand halten/testo 350 neu/testo 350 Instandhaltung Abgassonde reinigen @ 6\mod_1270039302035_79.doc @ 60667 @
7.5.
Cleaning the modular flue gas probe
✓ Disconnect the flue gas probe from the measuring instrument
prior to cleaning.
1. Release the probe catch by pressing the key on the probe
handle and remove the probe module.
When retrofitting a sensor the associated measurement
parameter and unit must be enabled, see Readings display,
page 33.
7 Maintaining the product
61