Emerson Rosemount 8800D Series Reference Manual page 50

Installation
May 2016
Cable connections
Refer to
cable to the electronics housing. (See
necting/disconnecting the meter adapter to the meter body.)
Figure 3-18. Remote Electronics Installation
Note: Consult factory for SST installation
A. Meter body
B. Support tube
C. Sensor cable nut
D. Nut
E. Washer
F. Union
G. Meter adapter
H. Coaxial cable
1.
2.
3.
4.
5.
42
Figure 3-18 and the following instructions to connect the loose end of the coaxial
I
H
G
F
E
D
C
B
A
If you plan to run the coaxial cable in conduit, carefully cut the conduit to the
desired length to provide for proper assembly at the housing. A junction box may
be placed in the conduit run to provide a space for extra coaxial cable length.
Slide the conduit adapter or cable gland over the loose end of the coaxial cable and
fasten it to the adapter on the meter body support tube.
If using conduit, route the coaxial cable through the conduit.
Place a conduit adapter or cable gland over the end of the coaxial cable.
Remove the housing adapter from the electronics housing.
"Remote electronics procedure" on page 88
O
N
M
L
I. ½ NPT conduit adapter or cable gland (supplied by customer)
J. Electronics housing
K. Coaxial cable nut
L. Housing adapter screws
M. Housing adapter
N. Housing base screw
O. Ground connection
Reference Manual
00809-0100-4004, Rev DC
if con-
J
K
I
Installation