Unloading; Warning; Storage; Detection Of Internal Fault - Haulotte HA16X Operator's Manual

Engine-powered articulated lifts, 12 - 26 m
F
- Special procedure
4.3 -

UNLOADING

Before operating, check that the machine is in good condition.
If the machine has been damaged during transportation, contact the transporter in writing.
1. Unlock the turntable rotation locking pin.
2. Remove the tie downs.
3. Start the machine.
4.4 -

WARNING

Upon starting a machine that has been secured then transported, the safety system may detect a false
overload forbidding all movement from the platform control box.
To reinstate the system, lift the jib a few centimetres from the ground control box.
Push the transport position selector ( 13 ) to the left to set the machine to operating position.
To unload the machine, select low driving speed
Do not travel down the ramp at a fast speed.
4.5 -

STORAGE

The machine must always be powered up when it is unfolded so that the security systems are active.
This means that the machine must be parked in stowed position.
The boom may be raised but it cannot be telescoped.
We strongly advise you not to store or immobilize the machine unfolded to avoid jeopardising the safety
of people and property.

5 - Detection of internal fault

5.1 -

PRINCIPLE

For machines fitted with.
• The machine is equipped with an on-board defect detection system.
• The number of times the defect indicator flashes indicates the type of fault to the operator.
• According to the type of fault, the machine switches in DOWNGRADED MODE; certain movements
can be limited or forbidden by the system to maintain the operator's safety.
N.B.-:-I
F THE EMERGENCY STOP IS ACTIVATED DURING TELESCOPE RETRACTION AND BOOM LIFT CONTROLS
ON RESTARTING
S
WITCH THE MACHINE OFF
2420332370
,
THE MACHINE SWITCHES TO
.
E06.11
.
DOWNGRADED MODE. S
TOW THE MACHINE COMPLETELY
EN
A
B
C
D
E
F
G
H
,
.
I
91