Operation; Test Procedure; Emergency Stop Button Operation; Tilt Sensor Switch Operation - Haulotte HA16X Operator's Manual

Engine-powered articulated lifts, 12 - 26 m
E
- Driving

3 - Operation

N.B.-:-T
HE FUNCTIONS ARE DESCRIBED FOR THE ENTIRE RANGE
THE CONTROLS AND FUNCTIONS INDICATORS
Find all the function indicators and controls in
3.1 -

TEST PROCEDURE

3.1.1 - Emergency stop button operation

Ground control box emergency stop button
Step
1
2
3
Platform control box emergency stop button
Step
1
2
3

3.1.2 - Tilt sensor switch operation

For ANSI models only :
Machine unfolded, the slope sensor gives an audible signal telling the operator that the machine should
not be deployed. In this case, fully lower the platform and reposition the machine on level ground before
raising the platform again.
• The audible beep sounds.
• For machines fitted with : The slope sensor prevents lifting and driving movements.
N.B.-:-M
ACHINE UNFOLDED
THAT THE BOOM COULD NOT RAISE
MACHINE ON A LEVEL GROUND BEFORE PERFORMING ANY RAISING OPERATIONS
2420332370
Pull the emergency stop buttons( 15, 46 ).
Turn the key on the control box activation selector switch ( 72 ) to the right to energize the
ground control box. The indicators light up.
Push the emergency stop button ( 15 ). The indicators go out.
Pull the emergency stop buttons( 15, 46 ).
Turn the key on the control box activation selector switch ( 72 ) to the left to energize the
platform control box. The indicators light up.
Push the emergency stop button ( 46 ). The indicators go out.
1. Pull the emergency stop push-buttons on the upper and lower control boxes (15, 46).
2. Switch on the machine from the lower control box (72, 230). All of the ground control box
indicators light up and a sound signal (beep) is emitted.
3. Start the machine (22).
4. Lift the boom or jib above horizontal.
5. Locate the tilt sensor next to the ground control box.
6. Manually tilt and maintain the tilt sensor towards the front for a few seconds
( Section C 2-Main components) :
,
THE TILT SENSOR GIVES AN AUDIBLE SIGNAL INDICATING TO THE OPERATOR
. I
E06.11
. R
.
Section C 5 - Control boxes
Action
Action
,
N THIS CASE LOWER THE MACHINE COMPLETELY
EFER TO THE MACHINE MODEL TO IDENTIFY
,
THEN REPOSITION THE
.
EN
A
B
C
D
E
F
G
H
I
71