Loading And Unloading; Principle; Loading By Lifting - Haulotte HA16X Operator's Manual

Engine-powered articulated lifts, 12 - 26 m
F
- Special procedure

4 - Loading and unloading

N.B.-:-W
RECOMMENDS POSITIONING THE COUNTERWEIGHT AT THE REAR
Raise the platform sufficiently to avoid contact with the ground.
To avoid any risk of tipping over, the boom must be maintained in the longitudinal axis of the chassis.
Section F 4.2Putting in transport position.
4.1 -

PRINCIPLE

To avoid any risk of sliding during loading, ensure that :
• The loading ramps can bear the load.
• The loading ramps are correctly attached.
• The loading ramp has sufficient grip.
As the slope of the ramp is usually greater than the authorised slope for driving, the arm and
boom must be lowered to enable driving to take place.
In this case, the buzzer is not activated and driving is authorised.
To climb the slope, select low driving speed
If the slope is too steep, use a winch in addition to traction.
Never place yourself below or too close to the machines during loading.
A wrong move can lead to the tipping over of the machine and cause serious bodily and material accidents.

4.1.1 - Loading by lifting

Ensure that :
• The machine is completely stowed.
• The platform must be empty.
• The lifting equipment ie. slings, shackles, hooks, lifting beam etc. are in good condition and of
sufficient capacity.
• The personnel performing the lift is authorised to complete the lift.
2420332370
HEN DRIVING UP AN INCLINE OR RAMP
E06.11
,
DURING LOADING OR UNLOADING
.
.
HAULOTTE®
EN 87
A
B
C
D
E
F
G
H
I