Procedure; On-Board Generator(Option)Option; Principle - Haulotte HA16X Operator's Manual

Engine-powered articulated lifts, 12 - 26 m
F
- Special procedure
5.2 -

PROCEDURE

Do not use the machine until the fault has been repaired.
Perform the required maintenance (see the machine maintenance book).
6 - On-board generator(Option)
6.1 -

PRINCIPLE

The on-board generator supplies voltage ( 220 V or 110 V depending on the option) in the
cage (or platform) able to connect a tool with the maximum power of 3 kW (4 Hp) .
Do not expose the on-board generator to direct contact with a water beam or a high pressure cleaner.
6.2 - PROCEDURE
Put into service :
1. Start the machine. Heat the engine during 15 mn befo-
re any operation.
2. Set the switch selector, above the socket power, to
ON 1. The green indicator comes on indicating the on-
board generator start-up.
3. Connect the tool to the socket.
4. You can change the tool at any time.
N.B.-:-W
MAKE ANY MACHINE MOVEMENTS
MUST SWITCH OFF THE ON
Power off :
5. Disconnect the tool from the socket.
6. Set the switch selector, above the socket power, to
OFF. The green indicator extinguish.
7. Machine movements are once again active.
92 2420332370
-
HEN USING THE ON BOARD GENERATOR
. T
-
BOARD GENERATOR
,
YOU CANNOT
,
O MAKE A MOVEMENT YOU
.
E06.11
1
EN