Loading And Unloading; Principle; Loading By Ramp; Unloading By Ramps - Haulotte C8 Operator's Manual

Electric scissor lifts
F
- Special procedure

3 - Loading and unloading

3.1 -

PRINCIPLE

3.1.1 - Loading by ramp

To avoid any risk of sliding during loading, ensure that :
• The loading ramps can bear the load.
• The loading ramps are correctly attached.
• The loading ramp has sufficient grip.
To climb the slope, select low driving speed
If the slope is too steep, use a winch in addition to traction.
Never place yourself below or too close to the machines during loading.
A wrong move can lead to the tipping over of the machine and cause serious bodily and material accidents.

3.1.2 - Unloading by ramps

Before operating, check that the machine is in good condition.
If the machine has been damaged during transportation, contact the transporter in writing

3.1.3 - Loading by lifting

Ensure that :
• The machine is completely stowed.
• The platform must not be loaded.
• The accessories are in good condition and of sufficient capacity.
• The personnel performing manoeuvres is authorised to use lifting material.
3.2 -

PUTTING IN TRANSPORT POSITION

The machine must be completely stowed.
1. Check the absence of load in the platform.
2. Secure the machine to the anchorage points provided for this purpose.
3. The guardrails must be locked and/or folded back.
4. Extensions must be locked and maintained with lanyards.
24203 3227 0
1. Remove the lanyards.
2. Start the machine.
3. The accessories are in good condition and of sufficient capacity.
4. The personnel performing manoeuvres is authorised to use lifting material.
E 10 09
(or ).
EN 83
A
B
C
D
E
F
G
H
I