Loading And Unloading; Principle; Loading By Ramp; Loading By Power Lift Truck - Haulotte STAR 6 Operator's Manual

Telescopic masts
F
- Special procedure

4 - Loading and unloading

N.B.-:-When traveling up slopes, during loading or unloading HAULOTTE® recommends positioning
the counterweight at the rear.
4.1 -

PRINCIPLE

4.1.1 - Loading by ramp

N.B.-:-The slope of the ramp is always greater than the maximum authorized slope. To authorise driving
:
• Lower the mast and jib.
To avoid any risk of sliding during loading, ensure that :
• The loading ramps can bear the load.
• The loading ramps are correctly attached.
• The loading ramp has sufficient grip.
• The machine is completely stowed.
If 2 ramps are used, ensure that the distance between them does not exceed 0,35 m(1 ft1 in).
If the slope is too steep, use a winch in addition to traction.
Never place yourself below or too close to the machines during loading.
A wrong move can lead to machine tip over which could result in serious injury or material damage.
For STAR 6 only
N.B.-:-In order to perform loading and unloading operations,
the operator can :
• Disconnect the upper control unit.
• Connect the upper control unit to the chassis.

4.1.2 - Loading by power lift truck

• Ensure that the machine controls are in the OFF position.
• Use a sufficiently powerful lift truck of sufficient capacity.
• Move the forks apart.
• Place the forks in the positions indicated on the chassis.
• Place the forks well under the machine to ensure optimum
stability.
2420343790 e10.11
77
AUS
A
B
C
D
E
F
G
H
I