3.2. Preventative Maintenance; Table 3-5: Preventative Maintenance; Www.aerotech.com - Aerotech A3200 Hardware Manual

Nmark CLS Hardware Manual

3.2. Preventative Maintenance

The Nmark CLS and external wiring should be inspected monthly. Inspections may be required at more
frequent intervals, depending on the environment and use of the system.
D A N G E R : Always disconnect the Mains power connection before opening the Nmark CLS
chassis.
Table 3-5: Preventative Maintenance
Check
Visually Check chassis for loose or damaged parts
/ hardware.
Note: Internal inspection is not required.
Inspect cooling vents.
Check for fluids or electrically conductive material
exposure.
Visually inspect all cables and connections.
Cleaning
The Nmark CLS chassis can be wiped with a clean, dry, soft cloth. The cloth may be slightly moistened if
required with water or isopropyl alcohol to aid in cleaning if necessary. In this case, be careful not to allow
moisture to enter the Nmark CLS or onto exposed connectors / components. Fluids and sprays are not
recommended because of the chance for internal contamination, which may result in electrical shorts and/or
corrosion. The electrical power must be disconnected from the Nmark CLS while cleaning. Do not allow
cleaning substances or other fluids to enter the Nmark CLS or to get on to any of the connectors. Avoid
cleaning labels to prevent removing the label information.

www.aerotech.com

Action to be Taken
Parts should be repaired as required. If internal
damage is suspected, these parts should be
checked and repairs made if necessary.
Remove any accumulated material from vents.
Any fluids or electrically conductive material must
not be permitted to enter the Nmark CLS.
Tighten or re-secure any loose connections.
Replace worn or frayed cables. Replace broken
connectors.
Chapter 5
Troubleshooting
59