Chapter 3: Maintenance; Table 3-1: Led Description - Aerotech A3200 Hardware Manual

Nmark CLS Hardware Manual

Chapter 3: Maintenance

Except for S1 and S2, the Nmark CLS does not have any user-configurable switches or jumpers.
D A N G E R : Always disconnect the Mains power connection before opening the Nmark CLS
chassis.
D A N G E R : Before performing any tests, be aware of lethal voltages inside the controller and
at the input and output power connections. A qualified service technician or electrician should
perform these tests.
Table 3-1: LED Description
LED Description
PWR* Turns green when power is applied.
STAT Turns green to indicate the laser output is firing. Turns red to indicate a fault condition on any
axis.
* If the power light flashes continuously and the unit does not operate, there is too much current draw from the 5V power supply or
the control supply voltage level is low.
www.aerotech.com Chapter 5
Troubleshooting
55