M30850T2-EPB User's Manual
2.8.2 If an Error is Detected in the Self-check
If the self-check does not result normally (ERROR 1 to ERROR 4 in Figure 2.6), check the following.
(1) Recheck the connection of the emulation probe and PC7501.
(2) Redownload the proper firmware.
Note on the Self-check:
If the self-check does not result normally (excluding user system errors), the emulation probe may be damaged.
Then contact your local distributor.
REJ10J1005-0200 Rev.2.00 April 1, 2007
IMPORTANT
2. Setup
Page 28 of 98