Starting Up The Emulator Debugger (Emem Dialog Box) - Renesas Emulation Probe M30850T2-EPB User Manual

M30850T2-EPB User's Manual

3.2 Starting Up the Emulator Debugger (EMEM Dialog Box)

(1) Status tab
1. Specifying the processor mode
Cancel
Notes on Selecting a Processor Mode:
When setting single-chip mode or memory expansion mode, the level of pin CNVSS of the MCU status should
be "L". The MCU status shows the pin level of the user system.
When setting microprocessor mode, the level of pin CNVSS of the MCU status should be "H".
When setting memory expansion mode or microprocessor mode, pins RDY# and HOLD# of the user system
should be "H".
When the user system is not connected, all modes are available.
REJ10J1005-0200 Rev.2.00 April 1, 2007
Help
IMPORTANT
3. Usage (How to Use the Emulator Debugger)
Specifying the processor mode
Select the appropriate processor mode that suits your
system.
Page 53 of 98