Message List - Renesas M16C FAMILY User Manual

6 Troubleshooting

6.14 Message List

The following lists the messages output by FoUSB.
Normal message
Your device has been automatically unlocked with the ID code.
The correct firmware already loaded on the USB Monitor Board.
Do you want to reprogram anyway
Programming in new firmware image
Download successful!!
Verify passed
A file has been loaded that will create an ID code of 00 00 00 00 00 00 00 on the
current attached device. Please make note of this!
Error message
The ID code did not match the one on the device
You are about to program Flash blocks that have not been erased yet.
Do
you want to continue?
Device is locked!
You must first unlock the device.
The USB Monitor Board is currently begin used as part of the KD30 Debugger
System.
Please close KD30 first before using the USB monitor board.
the firmware currently loaded on your USB monitor board doesn't support the
device your have selected.
Verify FAILED
The Flash memory on the device does not match the current loaded firmware file.
No Flash Blocks Selected
Please only enter numbers between C0000 and FFFFF only
USB Monitor could not erase that Flash Block
Error erasing device!!!
Erase Unsuccessful!!!
No File loaded
Vendor Read Request Error:
unable to complete GET_DEV_INFO command.
Unknown USB device attached!!
the target board that is attatched USB monitor board currently does not have its
own 5volt supply ---
Unable to place target MCU into syncronoos, BootMode
78