Other Notes - Renesas M16C FAMILY User Manual

3.4.3 Other Notes

Caution: The "USB Drivers" folder below is stored.
Driver Name
USBMON Driver
FoUSB Driver
(Note)
The Boot mode of USB MCU is used only for the use shown below.
1) Installation of FoUSB Driver
2) When the firmware of USB MCU is erased or damaged
When the firmware of USB MCU is erased or damaged, the phenomenon of [6.4 FoUSB cannot
operate Why?] or [6.6 A communication error occurs when the KD starts. What is the cause of
this problem?] occurs.
In this case, it is necessary to install FoUSB driver (first time only) and download firmware
compulsorily on a USB MCU. Please refer to [6.4 FoUSB cannot operate Why?].
Description
USBMON driver is a driver for using
FoUSB (Flash-over-USB) and KD (KD30,
KD3083)
FoUSB driver is a driver for using USB
MCU (M367641F8) of USB Monitor
Board in Boot mode. (Note)
23
3 Installing
Related Files
usbmon.sys
usbmon.inf
fousb.sys
fousb.inf