Renesas M16C FAMILY User Manual page 49

c) Start FoUSB. At this time, although the following error screen is displayed, ignore the
error and click the <OK> button.
d) Click the "Select MCU" button and download the firmware to the USB Monitor Board.
(Refer to 2) to 5) of this section for details)
e) When the download of the firmware is completed, Figure 4-25 will be displayed again.
Ignore the error and click the <OK> button. Finish FoUSB.
f) Remove the USB Monitor Board from host computer (PC), and set the power source
supply selector (S1: Power Mode) on the USB Monitor Board to the
(Refer to Figure 4-3)
g) Connect the PC, USB Monitor Board and Target Board.
h) Input 3.3V to the Target Board and USB Monitor Board from the external power.
FoUSB (KD30/KD3083 are included) can be used in 3.3V operation with the above
procedure.
Figure 4-25 Error screen
46
4 Using the FoUSB
TARGET side.