Siemens SIMOTION D425-2 Manual page 71

Position of connectors
The following figure shows the mounting position and designation of the connectors on the
control unit.
Figure 4-8
Note
For the X126 interface, an adapter connector is available for raising the PROFIBUS connector
to make more cabling space. This connector is required in certain wiring scenarios.
For further details, see
● Section Available spare parts and accessories (Page 135)
●
Interface assignment for X126
Table 4-17
Pin
1
2
3
4
5
6
7
SIMOTION D4x5-2
Manual, 04/2014
The position of the PROFIBUS X126 and X136 interfaces (example of SIMOTION D4x5‑2
DP/PN)
SIMOTION D4x5‑2 Commissioning and Hardware Installation Manual, Section
Connecting PROFIBUS DP
PROFIBUS DP interface X126
Signal name Signal type
-- --
M VO
1RS_DP B
1RTS_DP O
1M VO
1P5 VO
P24_SERV VO
Meaning
Reserved, do not use
Ground to P24_SERV
RS-485 differential signal
Request to send
Ground to 1P5
5 V power supply for bus terminal, external, short-circuit proof
24 V for teleservice, short-circuit proof, 150 mA maximum
Interfaces
4.7 PROFIBUS DP interfaces
71