List Of Interfaces - Siemens SIMOTION D425-2 Manual

NOTICE
Higher operating temperature if ventilation clearances are too small
The 80 mm clearances above and below the components must be observed.
The unit protects itself from overheating by shutting down.
The ventilation clearance is measured from the lower edge of the module, i.e. the fan/battery
module is not included in the dimension.
7.5.2.2

List of interfaces

The CX32‑2 has the following interfaces:
● 4 DRIVE-CLiQ interfaces
● 4 digital inputs/outputs
● 6 digital inputs
● Power supply connector
Available interfaces
Table 7-19
Interface
DRIVE-CLiQ interface
DRIVE-CLiQ interface
DRIVE-CLiQ interface
DRIVE-CLiQ interface
Digital inputs/outputs
Power supply connector
Measuring sockets (T0, T1, T2, and M)
Non-usable interfaces
Table 7-20
Interface name
RS232 interface
SIMOTION D4x5-2
Manual, 04/2014
Overview of available interfaces
Overview of interfaces that cannot be used for the CX32‑2
Supplementary system components
7.5 CX32-2 controller extension
Designation
X100
X101
X102
X103
X122
X124
X131 - X134
Interface
X140
Connector type
DRIVE‑CLiQ socket
DRIVE‑CLiQ socket
DRIVE‑CLiQ socket
DRIVE‑CLiQ socket
Mini Combicon, 3.5 mm,
1x14‑pin
Combicon, 4‑pin
Sockets
Connector type
9-pin Sub-D connector
119