Siemens SIMOTION D425-2 Manual page 50

Operator control (hardware)
3.3 7-segment and LED displays
Meaning of the LED displays
This table describes the LEDs and their meaning. The PN and
SIMOTION D4x5-2 DP.
Table 3-5
LED
RDY
RUN
STOP
SU/PF
SF
DP
DP/MPI
PN
SY/MT
OPT
Note
While the SIMOTION D4x5‑2 is ramping up, all LEDs are briefly illuminated in yellow.
7-segment display
The 7-segment display provides further status information in addition to the LED displays.
The status "6" and a flashing "." indicate that the D4x5‑2 has ramped up and communication
has been established to the SINAMICS Integrated.
Additional information
You can perform a detailed diagnosis with a PG/PC and the engineering system. Information
on the
Commissioning and Hardware Installation Manual and in the online help of this section via the
link under the
50
Error and status displays
Meaning
Operating states of SIMOTION D incl. SINAMICS Integrated.
User program is running
No user program is running. The technology packages are not active
The technology packages are active. The user program is not active
An error state of the SIMOTION D4x5‑2
State of the PROFIBUS DP interface
State of the PROFIBUS DP/MPI interface
State of the onboard PROFINET IO interface (X150)
- Synchronization status (SY) of the onboard PROFINET IO interface (X150)
- Maintenance status (MT) of the D4x5‑2 (currently without function)
State of the option module (if available).
Diagnostics via LED displays can also be found in the SIMOTION D4x5-2
Instructions menu.
SY LEDs have no function for
SIMOTION D4x5-2
Manual, 04/2014