Assembly; Assembling Ospe - Danfoss OSPE Service Manual

Service Manual

Assembly

Assembling OSPE

26
OSPE Steering Valve
Assembling OSPE
Place the two flat neutral position springs (from item 14)
in the slot of the spool (from item 1).
Place the curved springs between the flat ones and press
them into place.
Configuration of spring set (14).
There can be different numbers of curved springs
depending on configuration of spring set.
There can be 2, 4 or 6 curved springs.
OSPEF: Spool and sleeve must be positioned correctly
relatively to each other. Small marks are present on both
spool and sleeve close to one of the slots for the spring
set.
Guide the spool into the sleeve (1).
If the spool and sleeve has marks as shown above, these
must be placed on same side.
Make sure the neutral position springs (14) are placed
into the slot.
L1506577 • Rev 0001 • August 2015
150-386.10
150-412.10