Table of Contents
Advertisement
Service Manual
Assembly
OSPE Steering Valve
Assembling OSPE (continued)
Insert the O-ring (6) in the grove on the housing.
Place the distributor plate (34).
OSPED: the small ø4 mm hole of the plate (34) must be
placed above the ø3 mm hole in the housing The radial
channel groove of the plate (34) must be facing the
housing side.
Guide the cardan shaft (13) down into the bore so that
the slot is parallel with the connection flange for P, T, L
and R ports and lines up with the cross pin (12).
Place the 2 O-rings (39) in the two groves in the gear rim.
Fit the gearwheel with rim (30) on the cardan shaft (13).
Place the gear wheel side with all the deeper splines
facing downwards. Only this side will fit on the cardan
shaft due to all gear sets used in OSPE have timing
securing: splines of gear wheel and cardan shaft can only
be assembled with correct timing.
L1506577 • Rev 0001 • August 2015
33
Advertisement
Table of Contents
