Table of Contents
Advertisement
Service Manual
Service Literature
Symbols Used in Danfoss Literature
OSPE versions
OSPE Steering Valve
•
= Non removable part, use a new part
•
= External hex head
•
= Internal hex head
•
= Lubricate with hydraulic fluid
•
= Inspect for wear or damage
•
= Note correct orientation
•
= Mark orientation for reinstallation
•
= Torque specification
•
= Press in - press fit
•
= Pull out with tool - press fit
This service literature is valid for:
•
All OSPE's with single stage gear set
•
All OSPED with dual gear set. For the gear set end however only for V2/OSPED in new design
If the OSPED in question is in "old" or "V2/new" design can be traced by the product code:
•
OSPED's with product code number higher than 11113069 are all in "new" design
•
OSPED's with product code lower than 11113069 are all in "old" design
For further explanations between OSPED in "old" and "new" design, see Product Information Bulletin
ST2014-0139.
Service literature HN.21.ZA.52 is valid for gear set end of OSPED in "old" version.
L1506577 • Rev 0001 • August 2015
5
Advertisement
Table of Contents
