Danfoss OSPE Service Manual page 35

Service Manual
Assembly
OSPE Steering Valve
Assembling OSPE (continued)
OSPED: Place the rear distributor plate (117) so that the
channel holes match the holes in valve housing assembly
(122).
OSPED: Place the 2 O-rings (39) in the two groves in the
gear rim. Fit the gearwheel with rim (115) on the cardan
shaft (120).
Place the gear wheel side with all the deeper splines
facing downwards. Only this side will fit on the cardan
shaft due to all gear sets used in OSPE have timing
securing: splines of gear wheel and cardan shaft can only
be assembled with correct timing.
Place the end cover (36) in position. Ensure that the bar
codes and writing are parallel with the port face for P, T, L
and R connections.
OSPED: Fit the short screw (27) with washer (35) and
place it in the hole indicated by circle.
OSPED: Fit the six screws (31) with new washers (35) and
insert them.
Cross-tighten all the screws (27 and 31) using a 13 mm
socket spanner. 30 ±6 Nm.
OSPE: Has 7 identical screws (7x 31).
Replace the unit in the holding tool on gear set end. Use
appropriate support under the mounting surface for the
PVE to support the steering valve.
L1506577 • Rev 0001 • August 2015 35