Identification Data; Transport And Storage; Installation; Standard Assembly Kit - Danfoss OPTYMA Operation And Maintenance Manual

Control three-phase
Hide thumbs Also See for OPTYMA:
Table of Contents

Advertisement

OPTYMA
Control three-phase
TM

Identification data

A label bearing the following information is affixed to
the side of the product described in this manual
• Name of manufacturer
• Product type and code number
• Product name
• Power supply
• Compressor range
• Serial number (10 digits)
• Date (Day/Month/Year)

Transport and storage

Each control is carefully packaged to ensure that
it arrives undamaged under normal transport
conditions. Prior to transportation, please ensure
that:
• No objects or loose parts are inside the control.
• The door is correctly closed and locked.
• If the original packaging is not used, the
product is sufficiently packaged to allow safe
transportation

Installation

Installation to be done by authorised person only!

Standard assembly kit

The OPTYMA
Control three-phase unit is supplied with:
TM
• 4 rubber washers, to be fitted between the
fixing screws and the housing back panel
• 1 operation and maintenance guide
• 1 wiring instruction.
• 1 drilling layout.
• 2 sensors

Mechanical assembly

• Each control is designed to be wall-mounted;
please select an appropriate fixing method
depending on the weight.
• Install the device in places where the protection
rating is observed.
• To effect the correct electrical connection and
maintain the protection rating, use appropriate
cable glands and plugs to ensure a good seal.
© Danfoss A/S (RA Marketing/MWA), Nov. 08
Example:
The storage room must be of a suitable temperature
and low humidity; avoid contact between the
electrical control and aggressive contaminants that
could impair functioning and electrical safety.
• Install the device at an appropriate height for
• Install the device away from fire and heat sources
RS8FE102, 080R9278
Operation and Maintenance Guide
ease of use and maintenance. The installer must
not be put at risk when working on the panel.
The device must be located at a height of between
0.6 and 1.7 m from the ground.
and protect from the weather if necessary.
7

Advertisement

Table of Contents
loading

Table of Contents