Table of Contents
Advertisement
Service Manual
Assembly
28
OSPE Steering Valve
Assembling OSPE (continued)
C
Caution
Assembly pattern for standard bearing
1. Outer bearing race
2. Needlebearing
3. Inner bearing race
4. Spool
5. Sleeve
* The inside chamfer on the inner bearing race must face
the chest of the inner spool.
Place the steering valve housing with the port face down
on the work bench. Guide the outer part of the assembly
tool into the bore for the spool/sleeve set (1).
Grease the shaft seal (Roto Glyd, 7) with hydraulic oil and
place them on the tool. Ensure that the Roto Glyd seal is
placed on the insertion tool as per the photograph.
Hold the outer part of the assembly tool in the bottom of
the steering unit housing and guide the inner part of the
tool right to the bottom.
L1506577 • Rev 0001 • August 2015
Advertisement
Table of Contents
