Program Sequence Indicator; End Of Program - Miele PG 8593 Operating Instructions Manual

Operation
Top line
Middle line
Bottom line
Top line
Middle line
Bottom line
58

Program sequence indicator

After the program has started, the program sequence can be followed
in the display.
Universal
Main wash 1
Time left
– Program name, e.g.
The following parameters can be checked using the arrow buttons 
and :
– Current program block, e.g.
– Actual or required temperature
(depending on the display set, see "Further settings / Display:
Temperature").
– Cycle number,
– Conductivity
(only for machine version with conductivity meter)
– Time left (in hours; under an hour, in minutes)

End of program

A program is usually finished when the following parameters and
messages are shown in the display:
– Program name.
Continuously alternating between:
– Parameter met/not met
– Cycle number,
– Conductivity in final wash block
(only for machine version with conductivity meter)
– Program finished.
The LED in the Start/Stop button also goes out and the LED in the 
button begins to flash. In the factory default state an acoustic tone
also sounds for approx. 10 seconds (see "Settings  / Volume").
25 Min
Universal
.
Main wash 1
,