Cancel With Fault Code - Miele PG 8593 Operating Instructions Manual

Problem solving guide

Cancel with fault code

If a program is cancelled and a fault code appears, e.g.
a number), there could be a serious technical fault.
In the event of a program being cancelled and a fault number being shown:
Switch the machine off using the  button.

Wait approximately 10 seconds before switching the machine on again with the

 button.
Acknowledge the fault code by entering your PIN code. The standard PIN code is

"8000", however it may have been changed to a custom PIN code.
Start the previously selected program again.

If the same message appears again:
Make a note of the fault message.

Switch the machine off using the  button.

Contact the Miele Service Department.

Please also read the notes regarding the following fault numbers:
Problem
Fault 403-405
Fault 406-408
Fault 412-414
Fault 433
134
Possible cause and remedy
A program has been cancelled because water intake by the
machine was insufficient or severely restricted.
Turn on the taps fully.

Follow the further information given in the

intake
message.
A program was cancelled because the water inlet volume is
insufficient.
Check whether the taps are fully turned on.

Refer to the information regarding minimum flow

pressure in "Plumbing" and "Technical data".
Check the filter in the water inlet.

Contact Miele Service for advice.

A program was cancelled because the water inlet volume is
too high.
Refer to the information regarding recommended

maximum flow pressure and maximum permissible static
water pressure in "Plumbing" and "Technical data".
Contact Miele Service for advice.

Protruding wash load items are preventing the door from
being closed properly by the Comfort lock.
Sort the wash load so that it does not obstruct the door.

Close the door.

Fault XXX
(whereby XXX represents
Check water