Process Documentation - Miele PG 8593 Operating Instructions Manual

Process documentation

Memory
Adding cycle
number
114
Documenting processes
Processes are documented per cycle. Required and actual values are
always recorded.
During a program sequence the following data is recorded, among
other things:
– Machine type and serial no.
– Date
– Program start and program name
– Cycle number,
– Blocks used
– Dispensing system, dispensing temperature and required
dispensing quantity
– Required values for temperatures and exposure times
– Maximum and minimum temperature during exposure time
– Wash pressure measuring results
– All error messages
– End of program
– System messages, e.g. refill salt
Further data can be incorporated into the report as required. Contact
Miele for more information on this.
Depending on scale, between 10 and max. 20 cycle reports are
stored in an internal power failure safe memory within the machine. In
the event of e.g. network or printer problems these can be
subsequently recalled. If the memory is full, the oldest report is
overwritten.
Raw data for a graphic output of process data from the last program
is also stored. These can be converted into graphics by external
documentation software. The transmission of raw data requires an
Ethernet interface. Graphic representations in the display or as output
to a directly connected printer are not possible. There is no power
failure safe memory for graphic information.
Miele Service can add subsequent cycle numbers, e.g. in the event of
software updates or if the machine controls are replaced.