Operation
Top line
Middle line
Bottom line
Top line
Middle line
Bottom line
Ending the
program
58
Program sequence indicator
After the program has started, the program sequence can be followed
in the three-line display.
– Program name.
The following parameters can be checked using the arrow buttons
and :
– Current program block, e.g.
– Actual or required temperature
(depending on the display set, see "Further settings/Display:
Temperature"),
– Cycle number,
– Time left (in hours; under an hour, in minutes)
End of program
The following messages and parameters appear at the end of a
program:
– Program name.
– Temperature
(required temperature of the final wash phase)
– Program finished.
The LED in the Start/Stop button goes out as well. In the factory
default state, an acoustic tone also sounds for approx. 10 seconds
(see "Settings/Volume").
Open the door to end the program. The machine must be switched
on when you do this.
Normal
Main wash
Time left
15
Main wash
,
Min