Interface And Hardware Component Configuration Guide For Cisco Ncs 5500 Series Routers, Ios Xr Release - Cisco NCS 5500 Series Configuration Manual

Configuring Link Bundling
Example:
RP/0/RP0/CPU0:router(config-if)# bundle id 1 mode active
Specifies the bundle interface and puts the member interface in active mode.
Step 4 lacp period short
Example:
RP/0/RP0/CPU0:router(config-if)# lacp period short
Configures a short period time interval for the sending and receiving of LACP packets, using the default time period of
1000 milliseconds or 1 second.
Step 5 end or commit
Example:
RP/0/RP0/CPU0:router(config-if)# end
or
RP/0/RP0/CPU0:router(config-if)# commit
Saves configuration changes.
• When you issue the end command, the system prompts you to commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
- Entering yes saves configuration changes to the running configuration file, exits the configuration session, and
returns the router to EXEC mode.
- Entering no exits the configuration session and returns the router to EXEC mode without committing the
configuration changes.
- Entering cancel leaves the router in the current configuration session without exiting or committing the configuration
changes.
• Use the commit command to save the configuration changes to the running configuration file and remain within
the configuration session.
This example shows how to configure the LACP short period time interval to the default time of 1000
milliseconds (1 second):
config
interface HundredGigE 0/1/0/1
bundle id 1 mode active
lacp period short
commit
The following example shows how to configure custom LACP short period transmit and receive intervals to
less than the default of 1000 milliseconds (1 second):
config
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
Configuring the Default LACP Short Period Time Interval
107