Interface And Hardware Component Configuration Guide For Cisco Ncs 5500 Series Routers, Ios Xr Release - Cisco NCS 5500 Series Configuration Manual

Interface and hardware component configuration
Hide thumbs Also See for NCS 5500 Series:
Table of Contents

Advertisement

Configuring Ethernet OAM
Command or Action
Example:
RP/0/RP0/CPU0:router(config-eoam-lm)#
frame-seconds threshold low 3 threshold
high 900
Step 12
exit
Example:
RP/0/RP0/CPU0:router(config-eoam-lm)# exit
Step 13
mib-retrieval
Example:
RP/0/RP0/CPU0:router(config-eoam)#
mib-retrieval
Step 14
connection timeout <timeout>
Example:
RP/0/RP0/CPU0:router(config-eoam)#
connection timeout 30
Step 15
hello-interval {100ms|1s}
Example:
RP/0/RP0/CPU0:router(config-eoam)#
hello-interval 100ms
Step 16
mode {active|passive}
Example:
RP/0/RP0/CPU0:router(config-eoam)# mode
passive
Step 17
require-remote mode {active|passive}
Example:
RP/0/RP0/CPU0:router(config-eoam)#
require-remote mode active
Step 18
require-remote link-monitoring
Example:
RP/0/RP0/CPU0:router(config-eoam)#
require-remote link-monitoring
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
Purpose
the high and low thresholds must be specified. If the low threshold
is not specified, the default value is used. If the high threshold is not
specified, no action is performed in response to an event. The high
threshold must not be smaller than the low threshold.
The range is 1 to 900
The default value is 1.
Exits back to Ethernet OAM mode.
Enables MIB retrieval in an Ethernet OAM profile or on an Ethernet
OAM interface.
Configures the connection timeout period for an Ethernet OAM
session. as a multiple of the hello interval.
The range is 2 to 30.
The default value is 5.
Configures the time interval between hello packets for an Ethernet
OAM session. The default is 1 second (1s).
Configures the Ethernet OAM mode. The default is active.
Requires that active mode or passive mode is configured on the remote
end before the OAM session becomes active.
Requires that link-monitoring is configured on the remote end before
the OAM session becomes active.
Configuring Ethernet Link OAM
41

Advertisement

Table of Contents
loading

Table of Contents