Interface And Hardware Component Configuration Guide For Cisco Ncs 5500 Series Routers, Ios Xr Release - Cisco NCS 5500 Series Configuration Manual

Configuring Ethernet Link OAM
Command or Action
Step 19
require-remote mib-retrieval
Example:
RP/0/RP0/CPU0:router(config-eoam)#
require-remote mib-retrieval
Step 20
action capabilities-conflict {disable | efd |
error-disable-interface | log}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
capabilities-conflict efd
Step 21 action critical-event {disable |
error-disable-interface | log}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
critical-event error-disable-interface
Step 22 action discovery-timeout {disable | efd |
error-disable-interface | log}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
discovery-timeout efd
Step 23
action dying-gasp {disable |
error-disable-interface | log}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
dying-gasp error-disable-interface
Step 24 action high-threshold {disable |
error-disable-interface | log}
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
high-threshold error-disable-interface
Step 25 action remote-loopback { disable | log }
Example:
RP/0/RP0/CPU0:router(config-eoam)# action
remote-loopback disable

Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release

6.1.x
42
Purpose
Requires that MIB-retrieval is configured on the remote end before
the OAM session becomes active.
Specifies the action that is taken on an interface when a
capabilities-conflict event occurs. The default action is to create a
syslog entry.
Specifies the action that is taken on an interface when a critical-event
notification is received from the remote Ethernet OAM peer. The
default action is to create a syslog entry.
Specifies the action that is taken on an interface when a connection
timeout occurs. The default action is to create a syslog entry.
Specifies the action that is taken on an interface when a dying-gasp
notification is received from the remote Ethernet OAM peer. The
default action is to create a syslog entry.
Specifies the action that is taken on an interface when a high threshold
is exceeded. The default is to take no action when a high threshold
is exceeded.
Specifies that no action is taken on an interface when a
remote-loopback event occurs. The default action is to create a syslog
entry.
Configuring Ethernet OAM