Configuring Lacp Fallback - Cisco NCS 5500 Series Configuration Manual

Configuring Link Bundling
Example:
RP/0/RP0/CPU0:router# show bundle Bundle-Ether 3
(Optional) Shows information about the specified Ethernet link bundle.
Step 19 show lacp Bundle-Ether bundle-id
Example:
RP/0/RP0/CPU0:router# show lacp Bundle-Ether 3
(Optional) Shows detailed information about LACP ports and their peers.

Configuring LACP Fallback

This section describes how to configure the LACP Fallback feature.
SUMMARY STEPS
1. configure
2. interface Bundle-Ether bundle-id
3. ipv4 address ipv4-address mask
4. end or commit
5. show bundle infrastructure database ma bdl-info Bundle-e1010 | inctext
6. show bundle infrastructure database ma bdl-info Bundle-e1015 | inctext
DETAILED STEPS
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure
Enters global configuration mode.
Step 2 interface Bundle-Ether bundle-id
Example:
RP/0/RP0/CPU0:router(config)# interface Bundle-Ether 3
Creates and names a new Ethernet link bundle.
This interface Bundle-Ether command enters you into the interface configuration submode, where you can enter
interface-specific configuration commands. Use the exit command to exit from the interface configuration submode
back to the normal global configuration mode.
Step 3 ipv4 address ipv4-address mask
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x

Configuring LACP Fallback

97