Viewing Monitor Session Status: Example - Cisco NCS 5500 Series Configuration Manual

Viewing Monitor Session Status: Example

RP/0/RP0/CPU0:router(config)# monitor-session ms1
RP/0/RP0/CPU0:router(config-mon)# destination interface HundredGigE0/2/0/15
RP/0/RP0/CPU0:router(config-mon)# commit
RP/0/RP0/CPU0:router# configure
RP/0/RP0/CPU0:router(config)# interface TenGigE0/2/0/19
RP/0/RP0/CPU0:router(config-if)# monitor-session ms1 port-level direction rx-only
RP/0/RP0/CPU0:router(config-if)# commit
Viewing Monitor Session Status: Example
This example shows sample output of the show monitor-session command with the status keyword:
RP/0/RSP0/CPU0:router#
Monitor-session cisco-rtp1
Destination interface HundredGigE 0/5/0/38
================================================================================
Source Interface
--------------------- ---- ----------------------------------------------------
TenGigE0/5/0/4
TenGigE0/5/0/17
RP/0/RSP0/CPU0:router#
Monitor-session sess1
Destination interface is not configured
Source Interfaces
-----------------
TenGigE0/1/0/0
Direction: Both
ACL match: Disabled
Portion:
Status:
TenGigE0/1/0/1
Direction: Both
ACL match: Disabled
Portion:
RP/0/RSP0/CPU0:router# show monitor-session status error
Monitor-session ms1
Destination interface TenGigE0/2/0/15 is not configured
================================================================================
Source Interface
--------------------- ---- ----------------------------------------------------
Monitor-session ms2
Destination interface is not configured
================================================================================
Source Interface
--------------------- ---- ----------------------------------------------------
RP/0/RP0/CPU0:router# show monitor-session test status
Monitor-session test (ipv4)
Destination Nexthop 255.254.254.4
=========================================================================================
Source Interface
-----------------------------------------------------------------------------------------
Gi0/0/0/2.2
Gi0/0/0/2.3
Gi0/0/0/2.4
Gi0/0/0/4
RP/0/RP0/CPU0:router# show monitor-session test status error
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release
6.1.x
134
show monitor-session status
Dir Status
Both Operational
Both Operational
show monitor-session status detail
Full packet
Not operational (destination interface not known).
First 100 bytes
Dir Status
Dir Status
Dir Status
Rx Not operational (source same as destination)
Rx Not operational (Destination not active)
Rx Operational
Rx Error: see detailed output for explanation
Configuring Traffic Mirroring