Interface And Hardware Component Configuration Guide For Cisco Ncs 5500 Series Routers, Ios Xr Release - Cisco NCS 5500 Series Configuration Manual

Configuring Ethernet OAM
Command or Action
p2p xconnect-name}[id [icc-based icc-string
umc-string] | [ [number number]
Example:
RP/0/RP0/CPU0:router(config-cfm-dmn)#
service xconnect group X1
Step 5 continuity-check interval time [loss-threshold
threshold]
Example:
RP/0/RP0/CPU0:router(config-cfm-dmn-svc)#
continuity-check interval 100m
loss-threshold 10
Step 6 continuity-check archive hold-time minutes
Example:
RP/0/RP0/CPU0:router(config-cfm-dmn-svc)#
continuity-check archive hold-time 100
Step 7
continuity-check loss auto-traceroute
Example:
RP/0/RP0/CPU0:router(config-cfm-dmn-svc)#
continuity-check loss auto-traceroute
Step 8 end or commit
Example:
RP/0/RP0/CPU0:router(config-cfm-dmn-svc)#
commit
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
Purpose
is used only for down MEPs, or associate the service with a bridge
domain or xconnect where MIPs and up MEPs will be created.
The id sets the short MA name.
(Optional) Enables Continuity Check and specifies the time interval
at which CCMs are transmitted or to set the threshold limit for when
a MEP is declared down.
(Optional) Configures how long information about peer MEPs is stored
after they have timed out.
(Optional) Configures automatic triggering of a traceroute when a
MEP is declared down.
Saves configuration changes.
• When you use the end command, the system prompts you to
commit changes:
Uncommitted changes found, commit them before
exiting(yes/no/cancel)?
[cancel]:
• Entering yes saves configuration changes to the running
configuration file, exits the configuration session, and returns
the router to EXEC mode.
• Entering no exits the configuration session and returns the router
to EXEC mode without committing the configuration changes.
• Entering cancel leaves the router in the current configuration
session without exiting or committing the configuration changes.
• Use the commit command to save the configuration changes to
the running configuration file and remain within the configuration
session.
Configuring Ethernet CFM
51