Show Ethernet Cfm Local Meps Command: Examples - Cisco NCS 5500 Series Configuration Manual

Configuration Examples for Ethernet CFM

show ethernet cfm local meps Command: Examples

Example 1: Default
This example shows how to display statistics for local maintenance end points (MEPs):
RP/0/RP0/CPU0:router# show ethernet cfm local meps
A - AIS received
R - Remote Defect received
L - Loop (our MAC received)
C - Config (our ID received)
X - Cross-connect (wrong MAID)
P - Peer port down
Domain foo (level 6), Service bar
ID Interface (State)
----- ------------------------ --- -------- -- ------- ---
100 Gi1/1/0/1 (Up)
Domain fred (level 5), Service barney
ID Interface (State)
----- ------------------------ --- -------- -- ------- ---
2 Gi0/1/0/0 (Up)
Example 2: Domain Service
This example shows how to display statistics for MEPs in a domain service:
RP/0/RP0/CPU0:router# show ethernet cfm local meps domain foo service bar detail
Domain foo (level 6), Service bar
Down MEP on TenGigE0/0/0/1, MEP-ID 100
================================================================================
Interface state: Up
Peer MEPs: 0 up, 0 with errors, 0 timed out (archived)
CCM generation enabled:
AIS generation enabled:
Sending AIS:
Receiving AIS:
Domain fred (level 5), Service barney
Down MEP on TenGigE0/0/0/1, MEP-ID 2
================================================================================
Interface state: Up
Peer MEPs: 3 up, 2 with errors, 0 timed out (archived)
Cross-check defects: 0 missing, 0 unexpected
CCM generation enabled:
CCM defects detected:
AIS generation enabled:
Sending AIS:
Receiving AIS:
Example 4: Detail
This example shows how to display detailed statistics for MEPs in a domain service:
RP/0/RP0/CPU0:router# show ethernet cfm local meps detail
Domain foo (level 6), Service bar
Down MEP on TenGigE0/0/0/1, MEP-ID 100
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release
6.1.x
74
I - Wrong interval
V - Wrong Level
T - Timed out (archived)
M - Missing (cross-check)
U - Unexpected (cross-check)
Dir MEPs/Err RD Defects AIS
Up 0/0 N A
Dir MEPs/Err RD Defects AIS
Up 3/2 Y RPC
MAC address: 1122.3344.5566
No
Yes (level: 7, interval: 1s)
Yes (started 01:32:56 ago)
Yes (from lower MEP, started 01:32:56 ago)
MAC address: 1122.3344.5566
Yes (Remote Defect detected: Yes)
R - Remote Defect received
P - Peer port down
C - Config (our ID received)
Yes (level: 6, interval: 1s)
Yes (to higher MEP, started 01:32:56 ago)
No
Configuring Ethernet OAM
7
6