Interface And Hardware Component Configuration Guide For Cisco Ncs 5500 Series Routers, Ios Xr Release - Cisco NCS 5500 Series Configuration Manual

Configuring Ethernet Link Bundles
RP/0/RP0/CPU0:router(config-if)# no shutdown
RP/0/RP0/CPU0:router(config-if)# exit
RP/0/RP0/CPU0:router(config)# interface TenGigE 0/1/0/1
RP/0/RP0/CPU0:router(config-if)# bundle id 3
RP/0/RP0/CPU0:router(config-if)# no shutdown
RP/0/RP0/CPU0:router(config-if)# exit
(Optional) Repeat Step 8 through Step 11 to add more links to the bundle.
Step 14 end or commit
Example:
RP/0/RP0/CPU0:router(config-if)# end
or
RP/0/RP0/CPU0:router(config-if)# commit
Saves configuration changes.
• When you issue the end command, the system prompts you to commit changes:
Uncommitted changes found, commit them before exiting(yes/no/cancel)?
[cancel]:
• Entering yes saves configuration changes to the running configuration file, exits the configuration session, and
returns the router to EXEC mode.
• Entering no exits the configuration session and returns the router to EXEC mode without committing the configuration
changes.
• Entering cancel leaves the router in the current configuration session without exiting or committing the configuration
changes.
• Use the commit command to save the configuration changes to the running configuration file and remain within
the configuration session.
Step 15
exit
Example:
RP/0/RP0/CPU0:router(config-if)# exit
Exits interface configuration mode.
Step 16
exit
Example:
RP/0/RP0/CPU0:router(config)# exit
Exits global configuration mode.
Step 17 Perform Step 1 through Step 15 on the remote end of the connection.
Brings up the other end of the link bundle.
Step 18 show bundle Bundle-Ether bundle-id

Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release

6.1.x
96
Configuring Link Bundling