Configuring Ethernet Interfaces; Configuring Gigabit Ethernet Interfaces - Cisco NCS 5500 Series Configuration Manual

Configuring Ethernet Interfaces

This module describes the configuration of Ethernet interfaces.
The distributed 10-Gigabit, 40-Gigabit, 100-Gigabit Ethernet architecture delivers network scalability and
performance, while enabling service providers to offer high-density, high-bandwidth networking solutions.
These solutions are designed to interconnect the router with other systems in POPs, including core and edge
routers and Layer 2 and Layer 3 switches.
•
•

Configuring Gigabit Ethernet Interfaces

Use this procedure to create a basic Ethernet interface configuration.
SUMMARY STEPS
1. show version
2. show interfaces [HundredGigE | ] interface-path-id
3. configure
4. interface [HundredGigE| TenGigE] interface-path-id
5. ipv4 address ip-address mask
6. mtu bytes
7. mac-address value1.value2.value3
8. no shutdown
9. end or commit
10. show interfaces [HundredGigE | TenGigE] interface-path-id
DETAILED STEPS
Step 1 show version
Configuring Gigabit Ethernet Interfaces, page 17
Information About Configuring Ethernet, page 21
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
4
C H A P T E R
17