Interface And Hardware Component Configuration Guide For Cisco Ncs 5500 Series Routers, Ios Xr Release - Cisco NCS 5500 Series Configuration Manual

Configuring Ethernet Link OAM
SUMMARY STEPS
1. configure
2. interface [FastEthernet | HundredGigE| TenGigE] interface-path-id
3. ethernet oam
4. profile profile-name
5. commit
6. end
DETAILED STEPS
Command or Action
Step 1 configure
Example:
RP/0/RP0/CPU0:router# configure terminal
Step 2
interface [FastEthernet | HundredGigE| TenGigE]
interface-path-id
Example:
RP/0/RP0/CPU0:router(config)# interface
TenGigE 0/1/0/0
Step 3
ethernet oam
Example:
RP/0/RP0/CPU0:router(config-if)# ethernet
oam
Step 4 profile profile-name
Example:
RP/0/RP0/CPU0:router(config-if-eoam)# profile
Profile_1
Step 5 commit
Example:
RP/0/RP0/CPU0:router(config-if)# commit
Step 6
end
Example:
RP/0/RP0/CPU0:router(config-if)# end

Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release

6.1.x
44
Purpose
Enters global configuration mode.
Enters interface configuration mode and specifies the Ethernet
interface name and notation rack/slot/module/port.
• The example indicates an 8-port 10-Gigabit
Note
Ethernet interface in modular services card slot
1.
Enables Ethernet OAM and enters interface Ethernet OAM
configuration mode.
Attaches the specified Ethernet OAM profile (profile-name),
and all of its configuration, to the interface.
Saves the configuration changes to the running configuration
file and remains within the configuration session.
Ends the configuration session and exits to the EXEC mode.
Configuring Ethernet OAM