Interface And Hardware Component Configuration Guide For Cisco Ncs 5500 Series Routers, Ios Xr Release - Cisco NCS 5500 Series Configuration Manual

Configuring Link Bundling
Step 2
l2vpn
Example:
RP/0/RSP0/CPU0:router(config)# l2vpn
Enters L2VPN configuration mode.
Step 3
pw-status
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# pw-status
Enables pseudowire status.
Note • When the attachment circuit changes redundancy state to Active, Active pw-status is sent over the primary
and backup pseudowires.
When the attachment circuit changes redundancy state to Standby, Standby pw-status is sent over the
primary and backup pseudowires.
Step 4
xconnect group group-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn)# xconnect group grp_1
Enters the name of the cross-connect group.
Step 5
p2p xconnect-name
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc)# p2p p1
Enters a name for the point-to-point cross-connect.
Step 6
interface type interface-path-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# interface Bundle-Ether 1.1
Specifies the interface type ID.
Step 7
neighbor A.B.C.D pw-id pseudowire-id
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p)# neighbor 10.2.2.2 pw-id 2000
Configures the pseudowire segment for the cross-connect.
Optionally, you can disable the control word or set the transport-type to Ethernet or VLAN.
Step 8 pw-class {class-name}
Example:
RP/0/RSP0/CPU0:router(config-l2vpn-xc-p2p-pw)# pw-class c1
Configures the pseudowire class template name to use for the pseudowire.
Interface and Hardware Component Configuration Guide for Cisco NCS 5500 Series Routers, IOS XR Release 6.1.x
Configuring VPWS Cross-Connects in MC-LAG
115