Table of Contents
Advertisement
Installation and Setup
4. Connect the NovAtel or custom cable to the power supply and turn on the power supply. The power LED
on the receiver glows red when the AG-Star is properly powered.
Fuse/holder recommendations can be found in Table 9, Recommended Fuse and Fuse Holders
on page 49.
Minimum conductor size for all wiring is 0.5 mm / 20 AWG.
2.1.2
Power Supply Requirements
The AG-Star requires +8 to +36 VDC for the input power to the receiver. See Section A.2, AG-Star
Specifications on page 44 for additional power supply specifications.
The AG-Star cable provides power in (labeled BATT+) and power ground (labeled BATT-) bare wires for
connections from the AG-Star to a vehicular power system (or equivalent). For cable details see
Section A.2.3, AG-Star Connector and Cable Requirements on page 49.
The AG-Star power source must be protected by a 5A fast blow fuse (user supplied) or damage
to wiring may result (not covered by warranty).
AG-Star User Manual Rev 4
Figure 3: Simplified AG-Star Setup
COM
COM
CAN
MKI
PPS
Emulated
Radar
Chapter 2
User supplied
5A fast blow fuse
14
Advertisement
Table of Contents
