Novatel AG-Star User Manual page 55

Refer to the Command Formats section of the
examples.
 1. In NovAtel Connect there are two ways to initiate data logging to the receiver's serial ports.
You can either enter the LOG command in the Console window, or use the interface pro-
vided in the Logging Control window. Ensure the Power Settings on your computer are not
set to go into Hibernate or Standby modes. Data is lost if one of these modes occurs during
a logging session.
2. Only the ASCII/Abbreviated ASCII log table is included in this manual. Refer to the LOG
command in the
Field
Field
Name
1 LOG -
(ASCII)
header
2 port See Table 12, Detailed Serial
Port Identifiers on page 56
3 message Any valid message name, with
an optional A or B suffix.
4 trigger ONNEW
ONCHANGED
ONTIME
ONNEXT
ONCE
ONMARK
5 period Any positive double value larger
than the receiver's minimum raw
measurement period
6 offset Any positive double value
smaller than the period.
7 hold NOHOLD
HOLD
AG-Star User Manual Rev 4
OEMStar Firmware Reference Manual
OEMStar Firmware Reference Manual
ASCII Value
for binary log details.
Description
This field contains the command name or the
message header depending on whether the
command is abbreviated ASCII or ASCII
respectively.
Output port
(default = THISPORT)
Message name of log to output
Output when the message is updated (not
necessarily changed)
Output when the message is changed
Output on a time interval
Output only the next message
Output only the current message. (default)
Output when a pulse is detected on the mark 1
input, MK1I
Log period (for ONTIME trigger) in seconds
(default = 0)
Offset for period (ONTIME trigger) in seconds. If
you wished to log data at 1 second after every
minute you would set the period to 60 and the
offset to 1 (default = 0)
Allow log to be removed by the UNLOGALL
command (default)
Prevent log from being removed by the
UNLOGALL command
for additional
Field
Type
-
Enum
Char [ ]
Enum
Double
Double
Enum
55